Adding Sensitivity and Expression Using Optical Encoders on Electric Eel Generators

I recently upgrade the generators on my Electric Eel instruments to include optical encoders.  Check out this video to see how it works.

This means I'll be able to measure the speed and acceleration of the bow, leading to much more sensitive and expressive instruments.  I've been wanting to do this for YEARS and now it's finally happening...   

Over the years of playing my generator-based Electric Eel instruments, I have been enjoying how pushing them hard increases the sound volume.  It makes for sound so much more expressive than even my best MIDI keyboards with aftertouch.  It's slowly becoming apparent to me, though, that if I had a better idea how fast the player is pushing/sliding/bowing the generator, the sound could be even more sensitive and expressive.

Early on, I tried to do this by measuring the voltage on the temporary capacitors.   That approach works a little bit, but it doesn't change fast enough and different sound outputs consume the voltage at different rates, so it's way too entangled with the output sound, rather, than focused on what the player is doing.  Therefore, I decided to go WHOLE HOG and use an optical encoder.

This wasn't an easy decision.  These are more expensive and the algorithms get much more complex.  However, I am working again and don't have children (my instruments are my children!), so I went for it.  And actually I had a nice surprise---- over the last ten years, prices have come waaaaay down for these parts.  What used to cost about $300, can now be for only $40.  Yes, it's hard to believe.  It must be through the mass quantities of these parts that get used in factories.  Anyway, I picked up two of them and I've been wiring them up and writing code for them.  Soon I'll be putting them right into the instruments.  I can't wait.  It's going to be a whole new era.  In the meantime, please my newest video so you can share some the excitement that I'm going through!